Norscreen Filters Logo Techron Equipment Ltd Tel: 01903 732781
Norscreen Filters Cards accepted Mastercard and VISA
This is a trade site for business to business sales. Prices exclude both VAT, which will be charged at 20%, and carriage.
Click here for news page
Open 9 to 5 Mon Tue Thur Fri
Insect and rodent screen comprising mesh cylinder, protected by perforated metal outer, with sleeve to slide over the end of a pipe and a worm drive clip to secure in place
End of Line Screen Clamp Fitting
Set of parts to provide insect screening for warning or overflow pipe, up to 23mm OD, comprising a tank connector, the screen holder and a dip pipe
Warning Pipe Kit
Insect screen in a moulded plastic body, supplied with moulded in BSP male threads and a lift-off inspection and cleaning cover
Inline Screen up to 2 inch
Insect and rodent screen fitted into a section of BS PVC pipe
Inline Screen 2½ inch and above
Insect and rodent screen in a stainless steel body, provided with BSP sockets at both ends
Inline Screen all stainless steel with BSP sockets
Insect and rodent screen in a stainless steel body, provided with bolted flanges at both ends
Inline Screen all stainless steel with flange
Cowl vent for small cisterns, comprising a holder for an insect screen, with a cowl over it to exclude dust and dirt, which pushes onto the end of a connector. The connector has an integral washer and cutting marks, to allow it to be reduced in length by 25mm or 50mm, and is supplied with two EPDM washers and a ¾ inch BSP nut
Cowl Vent ¾ inch BSP
Grey PVC vent with insect screen. 4 inch BSP threaded shaft, fitted with two PVC nuts, one with a conformable foam washer. Grey PVC cowl over screen.
Cowl Vent 4 inch BSP
Contact Us
Hosting by Edge Hosting

End of Line Insect and Rodent Screens - clamp fitting

Steel pipe / Plastic pipe / Copper pipe

Person holding a very large end of line insect and rodent screen, standing in front of a yellow Techron Equipment van
End of line screen for 8 inch bore steel or plastic pipe

End of Line Screens

These screens are intended for use where access is not readily available to the overflow pipe and an inline screen is, therefore, difficult to fit. They are intended to fit the outflow end of the pipe and are normally used in refurbishing and upgrading existing systems.

The screens on this page are attached by sliding a sleeve over the end of an existing pipe and clamping it in place with a worm drive (Jubilee) clip. All parts are made from type 304 stainless steel.

Screens with BSP threaded socket connections are available and are covered on a separate page. Click here to view them

Click on any product image to view the individual product data sheet

Screens for Steel and uPVC pipes.

The sizes of these screens refer to the internal bore of the pipe, measured in inches. Approximate pipe ODs are shown for guidance, but may vary slightly according to the pipe material and wall thickness. For further information on pipe sizes, see the pipe sizes page.

End of Line Insect and Rodent Screens for Steel or PVC Pipe - Clamp fitting

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES050-022C

End of line screen for ½ inch bore steel or PVC pipe.
Nominal pipe OD 21mm
Body Diameter 50mm
Body Length 75mm
Sleeve length 45mm

£40.44 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES075-000C

End of line screen for ¾ inch bore steel or PVC pipe.
Nominal pipe OD 27mm
Body Diameter 50mm
Body Length 75mm
Sleeve length 45mm

£40.44 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES100-035C

End of line screen for 1 inch bore steel or PVC pipe.
Nominal pipe OD 35mm
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES125-042C

End of line screen for 1¼ inch bore steel or PVC pipe.
Nominal pipe OD 43mm
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES150-000C

End of line screen for 1½ inch bore steel or PVC pipe.
Nominal pipe OD 48mm
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES200-000C

End of line screen for 2 inch bore steel or PVC pipe.
Nominal pipe OD 60mm
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES250-076C

End of line screen for 2½ inch bore steel or PVC pipe.
Nominal pipe OD 73mm
Body Diameter 145mm
Body Length 150mm
Sleeve length 70mm

£104.35 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES300-000C

End of line screen for 3 inch bore steel or PVC pipe.
Nominal pipe OD 89mm
Body Diameter 145mm
Body Length 150mm
Sleeve length 70mm

£104.35 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES400-000C

End of line screen for 4 inch bore steel or PVC pipe.
Nominal pipe OD 115mm
Body Diameter 167mm
Body Length 250mm
Sleeve length 100mm

£125.56 each

The above sizes are normally held in stock.
The following sizes are only available to order. Delivery normally 5-6 weeks

End of line insect and rodent screen to suit 5 inch pipeClick here to view data sheet

ES500-000C

End of line screen for 5 inch bore steel or PVC pipe.
Nominal pipe OD 140mm

£200.17 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES600-000C

End of line screen for 6 inch bore steel or PVC pipe.
Nominal pipe OD 168mm

£222.48 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES800-000C

End of line screen for 8 inch bore steel or PVC pipe.
Nominal pipe OD 219mm

£457.13 each

Delivery £12 + VAT per order, up to 20kgs to most UK mainland destinations.
Small packages may be charged at a lower rate
Click on the product image to view full data sheet

Screens for Copper pipe

The sizes of these screens refer to the external diameter of the pipe, measured in millimeters.

End of Line Insect and Rodent Screens for Copper Pipe - Clamp fitting

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES000-015C

End of line screen for 15mm copper pipe.
Body Diameter 50mm
Body Length 75mm
Sleeve length 45mm

£40.44 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES050-022C

End of line screen for 22mm copper pipe.
Body Diameter 50mm
Body Length 75mm
Sleeve length 45mm

£40.44 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES000-028C

End of line screen for 28mm copper pipe
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES100-035C

End of line screen for 35mm copper pipe
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES125-042C

End of line screen for 42mm copper pipe
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES000-054C

End of line screen for 54mm copper pipe
Body Diameter 90mm
Body Length 100mm
Sleeve length 45mm

£60.00 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES000-067C

End of line screen for 67mm copper pipe
Body Diameter 145mm
Body Length 150mm
Sleeve length 70mm

£104.35 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES250-076C

End of line screen for 76mm copper pipe
Body Diameter 145mm
Body Length 150mm
Sleeve length 70mm

£104.35 each

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES000-108C

End of line screen for 108mm copper pipe
Body Diameter 167mm
Body Length 250mm
Sleeve length 100mm

£125.56 each

The above sizes are normally held in stock.
The following sizes are only available to order. Delivery normally 5-6 weeks

End of line insect and rodent screen to suit 133mm pipeClick here to view data sheet

ES000-133C

End of line screen for 133mm copper pipe

£200.17 each

 

Stainless steel insect and rodent screen comprising a perforated outer cylinder, lined with a fine mesh. One end is closed and the other has a smaller split cylinder, which can slide over the end of a pipe and be secured in place with the worm drive clip suppliedClick here to view data sheet

ES000-159C

End of line screen for 159mm copper pipe

£222.48 each

Delivery £12 + VAT per order, up to 20kgs to most UK mainland destinations.
Small packages may be charged at a lower rate
Click on the product image to view full data sheet

Note: None of the screens on this page require WRAS approval, as they only come into contact with water that is running to waste.