Norscreen Filters Logo Techron Equipment Ltd Tel: 01903 732781
Norscreen Filters Cards accepted Mastercard and VISA
This is a trade site for business to business sales. Prices exclude both VAT, which will be charged at 20%, and carriage.
Click here for news page
Open 9 to 5 Mon Tue Thur Fri
Insect and rodent screen comprising mesh cylinder, protected by perforated metal outer, with sleeve to slide over the end of a pipe and a worm drive clip to secure in place
End of Line Screen Clamp Fitting
Set of parts to provide insect screening for warning or overflow pipe, up to 23mm OD, comprising a tank connector, the screen holder and a dip pipe
Warning Pipe Kit
Insect screen in a moulded plastic body, supplied with moulded in BSP male threads and a lift-off inspection and cleaning cover
Inline Screen up to 2 inch
Insect and rodent screen fitted into a section of BS PVC pipe
Inline Screen 2½ inch and above
Insect and rodent screen in a stainless steel body, provided with BSP sockets at both ends
Inline Screen all stainless steel with BSP sockets
Insect and rodent screen in a stainless steel body, provided with bolted flanges at both ends
Inline Screen all stainless steel with flange
Cowl vent for small cisterns, comprising a holder for an insect screen, with a cowl over it to exclude dust and dirt, which pushes onto the end of a connector. The connector has an integral washer and cutting marks, to allow it to be reduced in length by 25mm or 50mm, and is supplied with two EPDM washers and a ¾ inch BSP nut
Cowl Vent ¾ inch BSP
Grey PVC vent with insect screen. 4 inch BSP threaded shaft, fitted with two PVC nuts, one with a conformable foam washer. Grey PVC cowl over screen.
Cowl Vent 4 inch BSP
Contact Us
Hosting by Edge Hosting

Inline Plastic Body Screen 2 inch BSP

Part Number LP200-054M

Description

Blue plastic inline insect screen, comprising a cylinderical body, with clip-on lid, having two 2 inch BSP male threaded connections at the base.   Click here to view full screen image
   
   
   

This is one of a range of inline plastic screens with male BSP connections in sizes from 1 inch to 2 inch.

The plastic cap may be removed to permit the cleaning or replacement of the insect screen. A clear 125mm is required above the cap to allow for removal of the screen.

Fitting

Positioning

The screen is rated to ½ bar. Do not mount it more than 1 metre vertically below the highest point of the overflow pipe.

The screen can be mounted in vertical, horizontal or inclined pipe. If mounted in a horizontal or inclined pipe, the body must not hang below the pipe.

The screen is not designed as a structural element. The pipework must be adequately supported, so that no load is transmitted to the plastic body.

2 inch steel or iron pipe

The screen may be fitted using normal 2 inch BSP threaded steel or malleable iron fittings. Depending upon the pipe layout, a union may be required to allow the screen to be removed later.

If space is restricted for threading the cut pipe, it may be easier to use steel pipe compression fittings with 2 inch BSP female sockets.

2 inch BS plastic pipe

The screen may be attached by solvent welding 2 inch BSP female connectors to the pipe and screwing these onto the screen. In some cases, it may be easier to fit the connectors to the screen body before solvent welding them in place.

54mm Copper Pipe

Two 54mm copper compression fitting adaptors with a 2 inch BSP female thread will be required for each screen.

Please note, we cannot supply any other BSP threaded fittings or any compression fittings referred to in this section.

Specification

Body: Blue polypropylene

Screen: Type 304 stainless steel 57 micron mesh