Norscreen Filters Logo Techron Equipment Ltd Tel: 01903 732781
Norscreen Filters Cards accepted Mastercard and VISA
This is a trade site for business to business sales. Prices exclude both VAT, which will be charged at 20%, and carriage.
Click here for news page
Open 9 to 5 Mon Tue Thur Fri
Insect and rodent screen comprising mesh cylinder, protected by perforated metal outer, with sleeve to slide over the end of a pipe and a worm drive clip to secure in place
End of Line Screen Clamp Fitting
Set of parts to provide insect screening for warning or overflow pipe, up to 23mm OD, comprising a tank connector, the screen holder and a dip pipe
Warning Pipe Kit
Insect screen in a moulded plastic body, supplied with moulded in BSP male threads and a lift-off inspection and cleaning cover
Inline Screen up to 2 inch
Insect and rodent screen fitted into a section of BS PVC pipe
Inline Screen 2½ inch and above
Insect and rodent screen in a stainless steel body, provided with BSP sockets at both ends
Inline Screen all stainless steel with BSP sockets
Insect and rodent screen in a stainless steel body, provided with bolted flanges at both ends
Inline Screen all stainless steel with flange
Cowl vent for small cisterns, comprising a holder for an insect screen, with a cowl over it to exclude dust and dirt, which pushes onto the end of a connector. The connector has an integral washer and cutting marks, to allow it to be reduced in length by 25mm or 50mm, and is supplied with two EPDM washers and a ¾ inch BSP nut
Cowl Vent ¾ inch BSP
Grey PVC vent with insect screen. 4 inch BSP threaded shaft, fitted with two PVC nuts, one with a conformable foam washer. Grey PVC cowl over screen.
Cowl Vent 4 inch BSP
Contact Us
Hosting by Edge Hosting

Inline Insect Screen 3 Inch Bore

Part Number LP300-076X

Description

Inline Plastic Body Insect Screen 3 inch bore

This screen is intended to be mounted in overflow pipes from water cisterns, to prevent the ingress of insects and vermin. The screen is a 57 micron type 304 stainless steel mesh mounted inside a section of Class C uPVC pipe. The screen area is at least 250% of the cross-sectional area of the pipe, to ensure there is no restriction to the flow of water.

The screen is supplied as a plain body for your own choice of solvent weld fixings to be applied, or for use with the flexible seal kit FS300-076C. Take care when choosing the fittings to ensure that the screen can easily be removed for periodic inspection and cleaning.

The body is 200mm long. Remove a section of the existing pipe sufficient for this length of body and for the fittings to be used. For use with the flexible seal kit, we suggest a section 200-205mm long is removed

Position

The screen is rated to 0.5bar maximum pressure and we recommend that it should not be mounted more than one metre vertically below the highest point of the water outlet. It may be fitted into either vertical or horizontal sections of pipe.

The screen is not designed as a structural element and it is important to ensure that the pipe is supported so as to avoid any load being transmitted to the screen.

Specification

Body: BS 3505 uPVC Class C pipe

Screen: Type 304 stainless steel 57 micron mesh

Associated Products

Flexible seal kit FS300-076C

Flexible seal kit to suit 3 inch inline plastic screen