Norscreen Filters Logo Techron Equipment Ltd Tel: 01903 732781
Norscreen Filters Cards accepted Mastercard and VISA
This is a trade site for business to business sales. Prices exclude both VAT, which will be charged at 20%, and carriage.
Click here for news page
Open 9 to 5 Mon Tue Thur Fri
Insect and rodent screen comprising mesh cylinder, protected by perforated metal outer, with sleeve to slide over the end of a pipe and a worm drive clip to secure in place
End of Line Screen Clamp Fitting
Set of parts to provide insect screening for warning or overflow pipe, up to 23mm OD, comprising a tank connector, the screen holder and a dip pipe
Warning Pipe Kit
Insect screen in a moulded plastic body, supplied with moulded in BSP male threads and a lift-off inspection and cleaning cover
Inline Screen up to 2 inch
Insect and rodent screen fitted into a section of BS PVC pipe
Inline Screen 2½ inch and above
Insect and rodent screen in a stainless steel body, provided with BSP sockets at both ends
Inline Screen all stainless steel with BSP sockets
Insect and rodent screen in a stainless steel body, provided with bolted flanges at both ends
Inline Screen all stainless steel with flange
Cowl vent for small cisterns, comprising a holder for an insect screen, with a cowl over it to exclude dust and dirt, which pushes onto the end of a connector. The connector has an integral washer and cutting marks, to allow it to be reduced in length by 25mm or 50mm, and is supplied with two EPDM washers and a ¾ inch BSP nut
Cowl Vent ¾ inch BSP
Grey PVC vent with insect screen. 4 inch BSP threaded shaft, fitted with two PVC nuts, one with a conformable foam washer. Grey PVC cowl over screen.
Cowl Vent 4 inch BSP
Contact Us
Hosting by Edge Hosting

Inline Stainless Steel Screen with 2½ inch BSP sockets

Part Number LS250-000F


Stainless steel insect and rodent screen comprising a section of 2½ imch pipe with 2½ inch BSP sockets at both ends

This is one of a range of inline plastic screens with female BSP connections in sizes from ¾ inch to 3 inches.


The screen is rated to ½ bar. Do not mount it more than 1 metre vertically below the highest point of the overflow pipe.

The screen can be mounted in any orientation, provided that the water flow is in the direction indicated on the label.

The screen is not designed as a structural element. The pipework must be adequately supported, so that no load is transmitted to the screen body.


The screen is designed to have a 2½ inch male BSP threaded pipe screwed into each end. Both ends have a right hand thread so it will be necessary to rotate at least one of the sections of pipe to connect the screen. If this is not possible, a rotating union should be used to connect to one of the pipes.

Ensure that the screen can be removed for occasional servicing. We recommend that it is removed and cleaned at least once every year.

Please note, we cannot supply any of the BSP threaded fittings referred to in this section.