Norscreen Filters Logo Techron Equipment Ltd Tel: 01903 732781
Norscreen Filters Cards accepted Mastercard and VISA
This is a trade site for business to business sales. Prices exclude both VAT, which will be charged at 20%, and carriage.
Click here for news page
Open 9 to 5 Mon Tue Thur Fri
Insect and rodent screen comprising mesh cylinder, protected by perforated metal outer, with sleeve to slide over the end of a pipe and a worm drive clip to secure in place
End of Line Screen Clamp Fitting
Set of parts to provide insect screening for warning or overflow pipe, up to 23mm OD, comprising a tank connector, the screen holder and a dip pipe
Warning Pipe Kit
Insect screen in a moulded plastic body, supplied with moulded in BSP male threads and a lift-off inspection and cleaning cover
Inline Screen up to 2 inch
Insect and rodent screen fitted into a section of BS PVC pipe
Inline Screen 2½ inch and above
Insect and rodent screen in a stainless steel body, provided with BSP sockets at both ends
Inline Screen all stainless steel with BSP sockets
Insect and rodent screen in a stainless steel body, provided with bolted flanges at both ends
Inline Screen all stainless steel with flange
Cowl vent for small cisterns, comprising a holder for an insect screen, with a cowl over it to exclude dust and dirt, which pushes onto the end of a connector. The connector has an integral washer and cutting marks, to allow it to be reduced in length by 25mm or 50mm, and is supplied with two EPDM washers and a ¾ inch BSP nut
Cowl Vent ¾ inch BSP
Grey PVC vent with insect screen. 4 inch BSP threaded shaft, fitted with two PVC nuts, one with a conformable foam washer. Grey PVC cowl over screen.
Cowl Vent 4 inch BSP
Contact Us
Hosting by Edge Hosting

Warning Pipe Insect Screen ¾ inch BSP

Insect screen for warning and small overflow pipes, comprising a ¾ inch BSP threaded tank connector, a dip pipe that plugs into the inner end of the tank connector and a screen body that pushes onto the outer end of the connector. The screen bosy has a lid that can be removed for access to the screen and a bottom outlet, which suits a variety of pipe sizes.

This screen is intended to prevent insects from entering a stored water system through the warning pipe. The set comprises a tank connector with a ¾ inch BSP thread, supplied with EPDM washers, an internal dip pipe and the screen unit. It is suitable for both a combined warning and overflow pipe in a small cistern and a separate warning pipe on a larger cistern.

The tank connector suits insulation up to 75mm thick. If space is restricted and the insulation is thinner, it can be reduced in length and cutting guides are moulded in at 25mm intervals.

The dip pipe is a press fit into the fitted tank connector, to prevent cold air from entering via the warning pipe. The tank connector should be fitted so that it is not less than 25mm above the full water level, but also so that this dip pipe is below the water surface when the cistern is full.

The screen unit comprises a plastic carrier, which is a push fit over the tank connector end and which holds a 57 micron stainless steel mesh insect screen. A screw cap allows the insect screen to be removed for cleaning. The outlet from the screen unit has a stepped hole, which is a push fit over either 22mm copper or 23mm plastic overflow pipe. The plain end can also be removed, to allow the use of the integral ¾ inch BSP male thread.

Part No: WP075-023M

Price: £9.71 + VAT per set

Carriage from £5.25 + VAT per order to most UK destinations